Recent content by Rede

I tried, but I don't like the precision of sensorless.

thank you, they were exactly these, for the moment I tried to create a bracket that follows the linked bracket (before changing the entire piece) but unfortunately I have this other problem. I tried different arms for the stealthburner but they all touch the cable carrier. Do you think I'm doing...

Hi, I have a question, do you know a bracket for the xy endstops which however is fixed (perhaps to be mounted on the x motor support) and not mounted on the y axis. Having mounted the can bus I no longer have the cable chain and therefore I wouldn't know how to pass the cables. Thank you. P.s...

sorry for the delay, you won't believe it but after being turned off for a week, today when it was turned back on it worked without problems. Klipper mysteries :)

the board is precisely the BIGTREETECH EBB SB2209/SB2240 CAN V1.0. the raspberry is a pi 4, the motherboard is an octopus 8p v1.1, the interface is the BIGTREETECH U2C V2.1. The settings are as follows...

yes, I connected the jumper on the ebb and on the u2c. The guide I followed is the one in the BTT manual and I tried exactly the guide you linked.

Hi, I need your help. Basically I had the bad idea of installing the BTT CAN BUS plate, specifically the EBB2209 + U2C. Leaving aside the crazy engineering choices, I've been trying to make it work for hours and hours but without success. I did all the steps and followed all the tutorials...

thanks, I didn't know this factor of the pi that could not receive the commands. Then I'll do the thing that cuts off the mains power.

Hi, I was wondering, is there a way to implement a physical emergency button on the printer? Let me explain better, as you know, the klipper emergency button is present on the screen which stops immediately, but in an emergency you don't have the readiness to go and look for it on the screen...

Thanks, I'll try pulling it manually.

Hi, I have a problem as per the title with the tensioner of the z motors, as you can see from the video, when I go to put the lever in position the belt remains too loose and causes me problems. In the video the white piece is made of pla printed on a machine calibrated to perfection, but I also...