Recent content by RichT

I'm not sure which kit and bought a year ago from someone on Facebook who lost interest. Thanks for the link. The mix of thicker and thinner makes sense with the M8x8 vs 12 screws. I'll put together using what I have that's right. Maybe a little duct tape and once I get working my first project...

BTW, was I supposed to wire the exhaust fan before putting the bottom panel on? I see that in a few steps on page 256 but I put the panel on in page 232. Must have missed that earlier.

While I don't seem to have enough parts, the parts I do have seem different sizes so thought I'd ask before sourcing anything. The assembly guide shows: Back and top panels using M3x8 screws. Eight corners and seven middle clips. Side panels using M3x12 screws. Eight corners and eight...

Unpluged the monitor and the Waveshare is fine. I'll just live with it alone though i like having the bigger to look at from a distance and only poke the little when I need to do something.

Yes, same content. Here’s pics of the big monitor and Waveshare

I have a 2.4 with an 25" monitor plugged into the HDMI port on the pi and a Waveshare 4.3 connected with the 15 pin cable to the pi. Big monitor is easier to see but I'd like to use the touchscreen. The monitor displays the full normal screen and the waveshare just the top left portion. Is it...

Solution after flashing the card @ 20 times was to go into sudo nmtui . The preconfigured settings looked fine but nothing was activated. I did once and now it boots up with a valid ip

Yes. 3B. Pic attached plus of the pi's display and the BigTree board. I thought I had the wifi settings like on the install mainsail page but could have made a mistake. Only takes a minute to do again.

Just to make sure nothing wrong with the pi 3 formatted a new card with the pi OS and started it with a monitor and keyboard. I expected the internet to work without any trouble but had to enter the wifi password again. No problems using. Bought a new SD card and installed mainsail. With the...

Bought a partially completed 2.4 that turns on. Home all moves the printhead to the back corner maybe an inch up but the quad corner level just moves to the front left and stops. How do I know what I have? I know there's a raspberry pi and a bigtreetech octopus board. Can I plug a monitor and...