Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Yup. I found 'em. It's Molex Mill-Grid 2.0. https://www.newark.com/molex/50394-8054/2mm-mgrid-crimp-term-wtb-chain/dp/99AC1780 I paid $15 for a 500 +s/h
Hi team!
I am not sure how to deal with that XT30. I want to use the IGUS CF9, and that's not easy with this connector. The insulation on the CF9 is very heat-sensitive, so it melts while I am soldering it. The data pins— JST PHD or Hirose DF11, whatever they are—are also not easy to deal with...
Unplugging the HEF did nothing. Still zero RPMs. It used to work. I would be thinking about the tach malfunction, if not for that "PWM" output. I tried to change the config for the HEF to the VFAN2 pin while keeping it plugged into VFAN1. Nothing happens. No PWM output in the RPMs
I switched HEF...
Hey team. I am experimenting with HB 4 wire 5015. It worked fine with this config:
[fan]
pin: gpio15
tachometer_pin: gpio12
tachometer_ppr: 2
[heater_fan hotend_fan]
pin: gpio13
heater: extruder
heater_temp: 50.0
I added a HEF to VFAN1, and the Tach started to act weird. It shows 0 PRM up until...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.