VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by Sliced_Weezel

  1. S

    PETG, first top layer after infill

    slowing down was the result which fixed it. I slowed down the ‘internal bridge’ speed and now no issues. Note, trying to increase infill didn’t help. I didn’t adjust temperatures in the end. (For me they remain at 250)
  2. S

    PETG, first top layer after infill

    Yeah I slowed it to 50% of my 300mm/s setup. Normal for final layers etc. I’ll try up infill am see what sticks!
  3. S

    PETG, first top layer after infill

    Hello everybody, Any suggestions on how to improve this issue I have with petg? The top layer after 15% gyroid infill has this tendency to tear through the centre areas, creating large holes. It then galls and smears shit everywhere This photo is using the ‘supporting dense layer’ included. I...
  4. S

    Tridex Build - 400 x 400(ish)

    Me either! Going to check mine next time I have 5 minutes
  5. S

    Tridex Build - 400 x 400(ish)

    I had similar bed mesh, tilting just the same. I have ended up improving by packing it out with tape. As you said, there is no mounting points in those spots, so hard to adjust. With tape I was able to get it to +- 0.15
  6. S

    Tridex Build - 400 x 400(ish)

    i think you have a good format! I don't think you'll regret going the size you have. It's hard to see in the pictures, but do the hotends extend past the build plate on X axis? As good as the stealth burners are, their size is a constraint in an idex configuration. For a few years I was using a...
  7. S

    Tridex Build - 400 x 400(ish)

    Brp just saw the title 😑
  8. S

    Tridex Build - 400 x 400(ish)

    Cool! What size have you gone for?
Top