Recent content by T-rav

I did not have wiring issues but also went with an ebb36 can board to minimize the number of wires that I had to deal with.

Not using the mini stealthburner its not. If you're set on using the rapido, you'll have to either modify the mini SB for the rapido or use a different toolhead like the Dragonburner.

What does your config look like for the A & B motors?

Is that creating a mesh? I've heard of the beacon sensor but haven't seen anyone use it yet.

This is only my opinion, if you're going to all the trouble to disassemble the printer to get rid of the drag chains, I would just convert to a canbus toolhead and minimize the number of wires going to the toolhead. Otherwise I would recommend getting a toolhead board so you only have 1 plug to...

yes if you are only printing PLA, no need for any type of enclosure. I can print PLA just fine on my by leaving the door off. I just start the preheat as I'm slicing the file and send it. No issues with cooling at all.

Remind me where you got the 3d model of the bed and texture for the V0 profile. I used to have this and did the "cleaning" of my hard drive this weekend and accidentally deleted my files and I don't recall where I got them.

So in Bullseye, it mentions enabling "Legacy Camera module". Even turning this on didn't seem to help. I am running buster on my V2 pi and this was never an issue. With my V0 I'm on bullseye I was never able to turn on legacy camera support and still have my touchscreen operate correctly...

finally got it sorted out. Unable to delete the post.

I can't get this waveshare display to work with my v0 along with a raspi-cam? I have a suspicion it has to do with an I2c conflict or dtoverlay problem but I'm not smart enough to figure it out. I had a larger waveshare display working with my v2 and a raspi-cam just fine. When I enable the...

That looks like it was a ton of filament swaps unless that was printed on the bambu.

I would print atleast 100 of them. The BOM for the V0.2 says 140 M3 nuts are needed. I've never built an LDO kit but I'm just wrapping up a V0 build and didn't use any of those inserts. It may be a nice thing to have but they are not necessary.

right after I printed all the parts but the tophat.... looks like I'll be tearing mine down and rebuilding it. o_O:geek:

Anyone have their exclude object stop working after implementing this? Not saying it’s the cause but it’s the only thing I’ve done to my printer recently and can’t seem to get exclude object working and it was working previously. Could be my pre-processing stopped working, just curious if...

Have you tried only preheating to a temp below where it oozes and then just before the print starts, to complete the heat up to print temp?