Recent content by the23rdwarrior

I think I reduced it to a acceptable level. I ended up replacing the MGN12 Rail but i don't know if this was really the culprit. Is only one Idler affected?

I switched the A / B Front Idlers around and dit a lot of tinkering but couldn not really improve this. Sometimes i got a good results when the gantry was in the front but as soon as i move the gantry to the back, the problem reappeared. I will try to print the default BFI Front Idler (I now...

I competly redone my belting and followed your instructions but couldn't solve the issue. But i noticed that the B Front Idler is looking like it is aligned too low in relation to the XY Joint idler. I will try to switch the Front Idlers to Check if the Problem then occurs on the other side or...

I also have the BFI front idler pin modded. By 'adjusted correctly' you mean tentioning the upper or lower screw until it works?

It's not recommended to have stealthChop activated on a/b motors but it's fine on z. Have fun!

Do you have stealthChop active on Z ?

My belts ride up and down on my B Idler on the x y joints. I checked belt tentioning carefully with the GT2 Meter to 2.5lb. I played around (tighten more up or down) with my BFI Front Idler but notthing seams to change anything....

Ok, thanks, I'll do that.

Ok, thanks, savs me some time :D Is there a further guide/resource on what to look for while printing the parts? I just found the official sourcing guide Like which are the most critial parts to fit together, which parts should be printed first to check strength e.t.c.

I'm the process of printing parts for a Voron Trident on my Ender-3 V2 Neo. Currently I'm still tuning my ABS Profile to get optimal results. I'm mostly following the Guide from Ellis and encountered the following: Voron parts are designed with ABS shrinkage in mind. You do not need any...