Recent content by TobyLies

I bought these cables for my screen (haven't installed yet though so I can't speak to quality): https://www.aliexpress.com/item/1005003739070641.html AMST-CMUP-DO, 0.2M https://www.aliexpress.com/item/4000772766370.html A2-A1

I thought I was ordering the correct power inlet, but alas, I did not. So I modified the stock integrated power inlet skirt model to fit the Astrodyne 082.01001.00 that I bought. The outside of the module does intrude into the space below the belt guard, so I'll need to modify the guard to...

Link to the mod? I was designing my own “backpack” for the stealthburner, but I’d love to see some alternative solutions

I haven't built it yet (aside from flashing Klipper and such), I'm still collecting parts. I will post it when it's up and running.

Thanks! I'm going to start with sensorless homing for now, so it will be just the TAP.

I'm building a new V2R2, and I'm using canbus and TAP. I'm using an EBB36 V1.2 canbus board with the OptoTap V2, and I'm hoping you guys can help me with the TAP sensor wiring. On the EBB36/40, there is a 5 wire endstop connector, with labelled pins +5V, GND, PB6, PB5, and PB7. The +5V and...

I'm starting my V2R2 build, and I'm also going canbus with TAP. How are you wiring the tap sensor into the canbus board? I'm using the EBB36, and it has a 5 wire "endstop" connector on the board. 1 wire is GND, 1 is +5V, and then 3 others. Is the SB2040 similar?

I was just sent this by Abyss3D, they're the ones I bought my printed parts from: https://ellis3dp.com/Print-Tuning-Guide/

Are you sure your 4 pin canbus connection is right? I read that the ebb36 is backwards compared to some of the other canbus boards.