Recent content by triafgg@

Also install KAMP, very easy to set up, very good instructions. Only levels the small area of the print. A small object wouldn't be affected by the high corner.

I would tighten down hard the one where it's red with other 3 looser, also you can pack up low bits a bit with aluminium tape, the sort used in heating/aircon ducting.

Just made sure it was bolted with one tight, two not so tight and one loose when it was hot and had good results since

I had the same issues, for me it was the commented out lines in the slicer gcode section, apparently klipper doesn't recognise the ; comment and executes what is on the line consequently running unwanted commands which led to it trying to extrude whilst still at 150C. Remove all comments from...

I have a Hartk StealthBurner 2 Piece board and when I was putting the SB cover on I think I misaligned the pins and shorted something out as the machine shutdown and restarted. Now I have no output on any fan pins. I have tested fans and they are OK. I am using TAP. When I replace the board it...

I tried different slicers, firstly S3D but that's too ancient to get a print but SuperSlicer gave a much better result which I think would suggest settings within the Orca slicer. Strange though as the Orca settings were transferred from SS initially and it is based on SS as I believe. There...

Just add, re the overhang. I can print the same part in ABS or PLA with no support and no issues and also with a flow rate up to 20 which is over 200 mm/s. My accel/decell is 5400/2700 which is lower than what input shaper suggests.

Hi, thanks for your response. I am printing with a volumetric flow rate of 4, which equates to 50 mm/s which I thought wasn't too fast for a voron with TPU. I can try slower, also I am doing wall inside out. I am still baffled as to why it goes good, then bad, then good again. I would have...

I am having a major issue with TPU. The first 30 layers are OK but then the next 70 or so are rubbish and the print is ruined, after that it prints perfectly for the rest of the job. I have tried different` levels of cooling but no difference. I don't understand why it can be good, bad and then...

Well done ark and Morat, you solved it for me. I had this in my slicer gcode commands, #M190 S[bed_temperature_initial_layer_single] #M109 S[nozzle_temperature_initial_layer] I assumed as hashed it was commented out but this was being sent in the gcode and as you rightly say the hashes were...

Wow, thanks I didn't know that. I'll look into what puts those into the code.

Also the bed heater starts heating the bed but the extruder temp is not powered so stays at ambient temp until the bed has reached the print temperature.

I've checked the gcode and all references to M109 are commented out as below. #M190 S120 #M109 S265 The printer.cfg has an M190 to set the bed immediately followed by an M109 S150 so I can't see where any other command can change the nozzle temp as I thought the Print_start macro would execute...

Hi when I start a print the bed temp goes up OK but then the nozzle goes up to print temp but I want it to go to 150 degrees before probing. Currently goes to 250(ABS) and then waits until it drops to 150 before probing. See part of printer.cfg. [gcode_macro PRINT_START] gcode: # This part...

Thanks for your replies. I tried uninstall/reinstall with kiauh but it stays the same, also when I click recover I don't get the hard/soft option it just goes to a box saying updating, but it never does and the error message 'Upater fluidd is not a Git Repo Type'. I think re-imaging the pi and...