Recent content by uc3d

A bit of a condescending tone, yet thanks for your answer. I would appreciate though if you don't frame in matter of need. I want to learn more about 3D printer designs. You replaced my question (how) with another question (should) and answer that instead. Not really helpful. I hope someone...

I have a v2.4 built with SB and I'd like to set it up to print up to 320C so to match some of the specs of Qidi X-plus-3. I know I could just get a high temp revo and slap it in, but I'd like to know if there are consequences that I should be aware of, like for instance printing the revo mount...

Thank you. I will try and investigate what strength features are different. Because ASA is similar but not quite ABS, and I would expect ABS-CF to be similar, but not worse than ABS.

Hi, In https://docs.vorondesign.com/materials.html it is recommended to use ABS. Steve Builds, in one stream, confessed that one of his printers actually uses CF-ABS. It seems that it was not approved of, at the time. Is that still the case? Any reason for not using CF-ABS? Thank you

I got a Fly SB2209 to drive my newly built SB. And it seems the wire for the revo heater core is too short. What's the recommended line of action here? Cut and splice an extension?

Thanks!

> certain features of certain parts may not turn out quite as well. as in "not look pretty" or "not work at all"?

Hi, I am going to start printing parts for my Voron v0, and when I checked the documentation, it gave me a very strict set of slicer parameters to print the parts. I'd like to ask then two questions: a) What would be the acceptable parameters for a 0.6mm nozzle? And if possible an...