Recent content by Venaticus

Yes, i was referring to that before. I requested heat and measured 0 Vs. Same goes for the nozzle too.

Yes, that is pretty much what happens. It is wired as it is shown below.

Fystect Github I got a Fysetc 0.2 Pro R1 Kit. I couldn’t print yet because of the obvious heating problem, but other than that everything seems to work fine. + Double-Checked the wiring + Used a different 24V power source + I can give the command that the heater should heat up but nothing...

Thank you for your answer, and I understand. Are there any benefits I would lose by removing the adapter?

Hello, thank you for your answer, it does help. I actually have realized that it is possible to assemble the hot end, this was. My concern was if I couldn’t assemble it in a way that would allow me to keep the adapter in place. If I am not mistaken (By no means an expert), removing the adapter...

Hello, so I am building my very first Voron which is a 0.2. I got a kit from fysetc which came with a Dragonfly hotend. I think the Assembly manual diverts from what I have. I don't have a clue how to connect my tool head with the hotend and also keep using the so-called adaptor of the hotend...