- Printer Model
- V0.2
I am planning to build a v0.2 and wondering what the difference is between the 12V and 24V Revo Voron? Which one is the normal one to go for?
Also the BOM asks for a raspberry pi. I am planning to run Klipper so should I swap this out for a Klipper Pi or is it easy enough to install Klipper on a Pi? (I've never done it before).
Finally, is it really difficult to build? I have built a Prusa MK3S, but have no experience other than that. Would a trident be significantly easier?
Also the BOM asks for a raspberry pi. I am planning to run Klipper so should I swap this out for a Klipper Pi or is it easy enough to install Klipper on a Pi? (I've never done it before).
Finally, is it really difficult to build? I have built a Prusa MK3S, but have no experience other than that. Would a trident be significantly easier?