Going to put an ERCF with ERCT on my V2.4 rebuild and kind of looking for thoughts and ideas for a few things.
How much real estate does it take up? I know the buffer will stick out the back but how far? Could you have the buffer to the front and still be able to easily load it? Ways to hold the filiment rolls, the repbox would work but I don't want to need a ladder to reach it. Can the rolls go in front of the buffer or is the back better? Best way to get the filiment into the toolhead (bowden tube placement) ? Only one I've seen was a slot cut in the top for the tube. Kind of hard to keep heat in that way. Just tring to keep problems/rework to a minimum so kind of open to anything.
How much real estate does it take up? I know the buffer will stick out the back but how far? Could you have the buffer to the front and still be able to easily load it? Ways to hold the filiment rolls, the repbox would work but I don't want to need a ladder to reach it. Can the rolls go in front of the buffer or is the back better? Best way to get the filiment into the toolhead (bowden tube placement) ? Only one I've seen was a slot cut in the top for the tube. Kind of hard to keep heat in that way. Just tring to keep problems/rework to a minimum so kind of open to anything.
