Hey folks. Does anyone know of a way to adjust top layer flow in prusa slicer or if there is a way? I know cura can do it and I think super slicer can but cura is a different beast and super slicer melts my mind. Is it something I’m just going to have to get used to? I have adjusted flow for my prints as per tuning guides however my top layers could do with 1 or 2 more percent to make them smoother. TIA
VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Adjust top layer flow
- Thread starter TechieNI
- Start date
