I'm finishing up a Double Dragon - an IDEX V0. It's based on an LDO V0.1 kit with a 24V 60W heater.
The 40mm bed fan can overpower the bed and even drop the bed temps. Even at 20% power for the fan and 100% for the bed.
Wondering if anyone else has this issue?
My current workaround is to just use the part cooling fan in the toolhead after the bed reaches temp to bring up the chamber heat. (I primarily print ABS) I move it to over the center of the bed and turn it on in the print_start macro.
The 40mm bed fan can overpower the bed and even drop the bed temps. Even at 20% power for the fan and 100% for the bed.
Wondering if anyone else has this issue?
My current workaround is to just use the part cooling fan in the toolhead after the bed reaches temp to bring up the chamber heat. (I primarily print ABS) I move it to over the center of the bed and turn it on in the print_start macro.
Last edited:
