Bed front and back

[Saikedo]

Printer Model

Voron 2.4r2 (350x350x350)

Hi everyone, sorry for a noob question. Any idea which is the front and which is back for this bed?
One side has 5 holes and the other side has 4 (the side with 4 holes also have 2 holes near it on the left and right sides).
Tried looking at the documentation and cad models but these holes are not shown there so I am not even sure if I will ever need the extra ones but wanted to check in to make sure.

And here is the link to where I purchased the bed just in case if it will help
And I believe this is the original manufacturer of the bed.

Thank you.

 

[120decibell]

That is a Mandala Roseworks bed. It has two sets of larger holes to fit both a V2 and a Trident. The smaller holes are for the ground wire and the thermal fuse as called out in the assembly manual.

 

[ah2049]

Based on the compatibility with the Trident, this should be the front.

 

[Saikedo]

Awesome guys, so the side with 5 holes is the back then. Thank you very much.