- Printer Model
- Voron 2.4r2
- Extruder Type
- Clockwork 2
- Cooling Type
- Afterburner
Hello all,
I seem to have a racking issue I cant shake. Attached are photos of each corner of the gantry where the linear rail sleds are. You can see there is a pretty noticeable gap on one side compared to the other. I have followed Neros deracking video and AndrewEllises deracking guide without much luck. Anyone have any ideas about what could be going on?
350mm Voron 2.4r2
Omron probe
Afterburner toolhead
Front right
![1000001238.jpg 1000001238.jpg](https://forum.vorondesign.com/data/attachments/3/3859-188af5ad032e36cc48bdf43f32d14716.jpg)
Right rear
![1000001235.jpg 1000001235.jpg](https://forum.vorondesign.com/data/attachments/3/3862-220aa1fd70eb7633a41053d07df769c1.jpg)
Front left
![1000001237.jpg 1000001237.jpg](https://forum.vorondesign.com/data/attachments/3/3860-d0b37ef00e191252adea828d64546467.jpg)
Left rear
![1000001236.jpg 1000001236.jpg](https://forum.vorondesign.com/data/attachments/3/3861-e770c7a99d976d2df35cec86575daf5c.jpg)
I seem to have a racking issue I cant shake. Attached are photos of each corner of the gantry where the linear rail sleds are. You can see there is a pretty noticeable gap on one side compared to the other. I have followed Neros deracking video and AndrewEllises deracking guide without much luck. Anyone have any ideas about what could be going on?
350mm Voron 2.4r2
Omron probe
Afterburner toolhead
Front right
![1000001238.jpg 1000001238.jpg](https://forum.vorondesign.com/data/attachments/3/3859-188af5ad032e36cc48bdf43f32d14716.jpg)
Right rear
![1000001235.jpg 1000001235.jpg](https://forum.vorondesign.com/data/attachments/3/3862-220aa1fd70eb7633a41053d07df769c1.jpg)
Front left
![1000001237.jpg 1000001237.jpg](https://forum.vorondesign.com/data/attachments/3/3860-d0b37ef00e191252adea828d64546467.jpg)
Left rear
![1000001236.jpg 1000001236.jpg](https://forum.vorondesign.com/data/attachments/3/3861-e770c7a99d976d2df35cec86575daf5c.jpg)