Solved Drivers, Jumpers and SPI

[almightyjes]

hey again,
so im waiting for a new MCU spider v3 and i also decided to get some TMC2240 drivers(they got here today), now i didn't do enough research before buying since i thought drivers were somewhat plug and play, turns out they aren't.
therefore i am again asking for your help.
the driver is SPI only, my questions are:
1st, the SPI-CLK and SCK/MS2 are those compatible with each other (driver and board pins picture)?
2nd, if they are compatible should my jumpers be set like this?:
or ?
driver and board pins:



github of board:

FYSETC-SPIDER/hardware/V3.0 at main · FYSETC/FYSETC-SPIDER

FYSETC Board - 3d printer motherboard for VORON and other open source project. - FYSETC/FYSETC-SPIDER

github.com

i could not find github for the driver only their sales site:

BIGTREETECH TMC2240 V1.0

BIQU is a powerful 3D printing products manufacturer. We provide mainboard, extruder and 3D printer. Our products are also compatible with other brands of 3D printer, Creality Ender series, Anycubic FDM 3D printer, Voron etc.

biqu.equipment

hope this is possible

 

[almightyjes]

Update: after a lot of searching the wrong things on Google i ended up figuring out my questions i think,.
1st. yes, Spi-clk is the same as sck.
2nd. the jumper need to be all on bottom

 

[Elijah]

Update: after a lot of searching the wrong things on Google i ended up figuring out my questions i think,.
1st. yes, Spi-clk is the same as sck.
2nd. the jumper need to be all on bottom

hi. could u to share ur printer.cfg on BTT 2240 and spider 3?

 

[NoGuru]

I have a couple 2240's but have not tested them yet. Maybe in the next week or two i will.