llambion
Member
I bought two fystec tmc2240 drivers to replace tmc2209 X and Y drivers on spider 2.3 motherboard.
I put the jumpers according to the instructions that fysetc has for the TMC5160, so all 4 jumpers plugged in.
After they installed and changed printer.cfg configuration, when i try to do a home, this error is shown!! Unable to write tmc spi 'stepper_x' register DRV_CONF.
The same error is shown on stepper y, if a try to do a Y home
TMC2209 drivers work perfectly if i swap them
I put the jumpers according to the instructions that fysetc has for the TMC5160, so all 4 jumpers plugged in.
After they installed and changed printer.cfg configuration, when i try to do a home, this error is shown!! Unable to write tmc spi 'stepper_x' register DRV_CONF.
The same error is shown on stepper y, if a try to do a Y home
TMC2209 drivers work perfectly if i swap them