thespacecowboy
Active member
Everything is set up, and everything attached to the nitehawk works except the extruder. There are no errors thrown by anything that I can see.
What should I look at? this is a brand new LDO extruder for clockwork 2
At the nitehawk, I tested the pins for the extruder,
black and green have 2.6v on them seemingly always, red and blue have 2.2v on them, both seemingly always
Is this a bad motor??? If it is only that I have to wait a week to find out
What should I look at? this is a brand new LDO extruder for clockwork 2
At the nitehawk, I tested the pins for the extruder,
black and green have 2.6v on them seemingly always, red and blue have 2.2v on them, both seemingly always
Is this a bad motor??? If it is only that I have to wait a week to find out
Last edited:
