What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Fan problems after g2e

NegativeFate

New member
Printer Model
2.4
Extruder Type
Galileo
Cooling Type
Stealthburner
Hey all, put the g2e in last night and when I was finished I went to start some calibrations.. but during the print_start I get this message “the value ‘Fan’ is not valid for FAN”
Had a look in the klippy log and it doesn’t really tell me much (that I can see anyway) hoping someone has any ideas?
 

Attachments

  • klippy.txt
    123.4 KB · Views: 2
[heater_bed]
heater_pin = PD13
sensor_type = ATC Semitec 104GT-2
sensor_pin = PF3
max_power = 1
control = pid
pid_kp = 22
pid_ki = 1.08
pid_kd = 114
min_temp = -80
max_temp = 115

[fan] <-----------------------
pin = ebb:gpio13
max_power = 1
kick_start_time = 1


[heater_fan Hotend]
pin = ebb:gpio14
max_power = 1
shutdown_speed = 1
heater = extruder
heater_temp = 50.0

I think this fan might need a description set. Try using

[fan_generic]​

 
All sorted mate, was a problem with the print_start macro
As far as I’m aware.. [fan] can’t be changed? I stand to be corrected tho
 
Top