What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Question Filament battles - What is you experience with Inland ABS?

DustinSpeed

Well-known member
Staff member
Voron Owner
What has been your experience with printing both for and on your voron.

Do you like the color selection?

Does it print well?

Any special considerations?

Is it worth the price?
 

DustinSpeed

Well-known member
Staff member
Voron Owner
I personally like a brighter color most of the time. These seem muted to me. Prints fine. Prints like normal ABS. It's definitely cheap.
 

Urufu_Shinjiro

New member
My go to for most printing, lays down real nice, prints better than KVP IMO without all the hassles of KVP and can be had for super cheap on Amazon.
 

Yeri

Active member
Staff member
Moderator
Voron Owner
I picked up a few spools cheap on amazon for a test, I use these as my prototyping filament since they print pretty consistently. I've seen a few places where there are cooling issues, so you may want to up the fan speed a bit on these, but I haven't done a full and proper filament tune on this.
 

egar

Member
Just bought my first spool of this. I was impressed with how well it printed. I typically print with Polymaker Polylite ASA and printed the Inland with the same settings (245 nozzle / 100 bed). The quality of the results were the same. For the more than 40% savings on cost, I think it is a good deal. It is also convenient to be able to stop by the local Microcenter and pick up a spool. Microcenter has limited color choices, but the basics are readily available.
 
Top