What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

filiment stuck in hotend

skylab

New member
i recently purchased a used voltron and it worked for 5 minutes some filament broke off in the hotend and, i tried the usual tricks of heating it up to 280 trying to put the obstruction out using a wire, but nothing seems to be able to disloge the blockage and ii dont want to break it y forcing it too hard and bending the frame or breaking something else.. my last resort before disasembing it is to reach out here for any ideas
 

Attachments

  • voltron2.jpg
    voltron2.jpg
    201.7 KB · Views: 8
What is the hotend, extruder, and toolhead type?
What caused the blockage?
 
What is the hotend, extruder, and toolhead type?
What caused the blockage?
Its ok i finally got the blockage out now ia looking for a 3d designer to get my dimension and pictures of my prototype lamp base which i fabricated in wood and now needs to be 3d printed i was looking at fiverr to have my project ready for 3d printing. Any other recommendation where i can get this job done cheap is welcome
 
If you unblocked your voltron hotend, why do you not print it yourself? If you find somebody on the internet, chances are you will be many miles apart from eachother. Better find somebody local to you or print it yourself.
On this forum, which is dedicated to Voron printers, your will unlikely find this service.
 
Top