- Printer Model
- VORON 2.4r2
- Extruder Type
- Clockwork 2
- Cooling Type
- Stealthburner
I don't know if this is the right forum for this question and I hope it's not a dumb question with an obvious answer, but here goes...
When you get the functional ABS parts from PIF or Etsy sellers, etc. they don't come with panel clips or the exhaust cover. It seems like both of these would be required to enclose the printer. It's my understanding that an enclosed chamber is required to print ABS. So, it seems like a chicken-and-egg situation. How do I print the panel clips and exhaust cover without an enclosed chamber? I'm also concerned about fumes so I have a Nevermore ready-to-go, but again, I need my chamber enclosed. Can I just tape them on with aluminum tape or something temporarily? Is that how this is handled?
Thanks.
When you get the functional ABS parts from PIF or Etsy sellers, etc. they don't come with panel clips or the exhaust cover. It seems like both of these would be required to enclose the printer. It's my understanding that an enclosed chamber is required to print ABS. So, it seems like a chicken-and-egg situation. How do I print the panel clips and exhaust cover without an enclosed chamber? I'm also concerned about fumes so I have a Nevermore ready-to-go, but again, I need my chamber enclosed. Can I just tape them on with aluminum tape or something temporarily? Is that how this is handled?
Thanks.