Latest Updates and Cartographer 3D

[Dr.Who12]

A few days ago I noticed that I had some updates for my Voron. I proceeded to do all of them and after they were done, Klipper rebooted and it came up with an error about a depreciated setting. No worries. But then my Cartographer 3D told me I needed to recalibrate the sensor, so I did. Now, even though I calibrated it, the print head is too low and my benchy test prints are having issues on the bow. I've tried doing the calibration again but I'm getting the same result. Raising the Z height manually before printing was not necessary before and my prints came out great. Nothing else has changed. Has anyone else run into this and if so, what did you do to fix it?

 

[Laserbea4k43]

Hi, not sure if you've fixed it yet, but the updated Cartographer docs will walk you through it. You'll need to update the firmware, edit your config, and follow a new procedure.

 

[Dr.Who12]

Hi, not sure if you've fixed it yet, but the updated Cartographer docs will walk you through it. You'll need to update the firmware, edit your config, and follow a new procedure.

Thanks. I got it and found some steps I missed the first time I set it up. Works fine now.