kholland15
Member
- Printer Model
- Enderwire
- Extruder Type
- Clockwork 2
- Cooling Type
- Stealthburner
Anyone experience a loud click or Pop on your Switchwire/Enderwire during certain printer movements?
I know its not the extruder since I have heard it while the printer was homing. It seems to be more prevalent when the print head is 1" above the bed, but can happen when its higher or lower. It doesn't seem to have any effect on my print quality so I don't think the linear rails are binding.
My theory is that it is either the cable chains popping, or the keyback popping. Has anyone else experienced this before?
Video of pops
I know its not the extruder since I have heard it while the printer was homing. It seems to be more prevalent when the print head is 1" above the bed, but can happen when its higher or lower. It doesn't seem to have any effect on my print quality so I don't think the linear rails are binding.
My theory is that it is either the cable chains popping, or the keyback popping. Has anyone else experienced this before?
Video of pops
Last edited:
