Loud click/pop every once in awhile?

[kholland15]

Printer Model

Enderwire

Extruder Type

Clockwork 2

Cooling Type

Stealthburner

Anyone experience a loud click or Pop on your Switchwire/Enderwire during certain printer movements?

I know its not the extruder since I have heard it while the printer was homing. It seems to be more prevalent when the print head is 1" above the bed, but can happen when its higher or lower. It doesn't seem to have any effect on my print quality so I don't think the linear rails are binding.

My theory is that it is either the cable chains popping, or the keyback popping. Has anyone else experienced this before?
Video of pops

 

[3dCase]

Anyone experience a loud click or Pop on your Switchwire/Enderwire during certain printer movements?

I know its not the extruder since I have heard it while the printer was homing. It seems to be more prevalent when the print head is 1" above the bed, but can happen when its higher or lower. It doesn't seem to have any effect on my print quality so I don't think the linear rails are binding.

My theory is that it is either the cable chains popping, or the keyback popping. Has anyone else experienced this before?
Video of pops

I had a CR10S PRO-V2 which did this and it turned out I had crimped my X belt with metal belt stops that were slightly bigger then the originals. Upon homing it caught the Z collumn and made a “twang” noise as it jumped free after getting caught.
Maybe you have something similar with either or all of your belts.