- Printer Model
- Sioboor 2.4 R2
- Extruder Type
- Clockwork 2
- Cooling Type
- Stealthburner
Hi all
Having an issue with a new 2.4 build, i have a BTT Octopus pro that had a Z motor completely stop working half way through the setup. Had got as far as bed levelling with no issues with any component then when i was looking at Elli's tuning guide and went to home the toolhead that's when it stopped. No errors just nothing happening when trying to move or buzz that motor. I move the motor from drive 5 to drive 6 on the board and it work with no issues. I went back to the start of the setup and now when i try to buzz the Z motors i have issue. buzzing Z1 does not move Z1 at all, and buzzing Z moves both Z and Z1 at the same time, the other 2 work fine. Is it worth flashing the firmware or do i just replace the board ??
Cheers
Having an issue with a new 2.4 build, i have a BTT Octopus pro that had a Z motor completely stop working half way through the setup. Had got as far as bed levelling with no issues with any component then when i was looking at Elli's tuning guide and went to home the toolhead that's when it stopped. No errors just nothing happening when trying to move or buzz that motor. I move the motor from drive 5 to drive 6 on the board and it work with no issues. I went back to the start of the setup and now when i try to buzz the Z motors i have issue. buzzing Z1 does not move Z1 at all, and buzzing Z moves both Z and Z1 at the same time, the other 2 work fine. Is it worth flashing the firmware or do i just replace the board ??
Cheers
