LightsOutLabs
Member
- Printer Model
- V0.1
Hi, blind guy again. I'm getting dreadful prints, and noticed that the part cooling fans on either side of the head don't appear to be winding up. I've got a Revo hot end and the it's direct drive.
I have a couple of questions:
1. Aside from using the k Klipper web interface to turn up the part cooling fans, are there any other tests I can do? I did use some GCode, M something or other to turn them on and I can feel them almost vibrating, as if there is power going into them but they are simply not getting moving.
Secondly, is it possible to put on a fresh config for the printer into Klippe? I'm concerned I've messed something up in my attempts to tune.
Cheers
Ollie
I have a couple of questions:
1. Aside from using the k Klipper web interface to turn up the part cooling fans, are there any other tests I can do? I did use some GCode, M something or other to turn them on and I can feel them almost vibrating, as if there is power going into them but they are simply not getting moving.
Secondly, is it possible to put on a fresh config for the printer into Klippe? I'm concerned I've messed something up in my attempts to tune.
Cheers
Ollie
