- Printer Model
- Voron 2.4 R 2
- Extruder Type
- Clockwork 2
- Cooling Type
- Stealthburner
I have completed the construction of a Voron 2.4 R2 and I'm doing the checkout. I've reached the point where I'm establising the 0,0 point.
I send a G28 X Y command and the toolhead goes to the correct position, X 350 Y 350
I then use the Toolhead window to set the X position to 0 and the toolhead goes the the left, back of the print bed correctly.
I then use the Toolhead window to set the Y position to 0 and the toolhead moves to the middle of the board and rattles while moving.
I then send a G28 X Y command and the toolhead goes to the correct position at X 350 and Y 350.
I then use the Toolhead Window to set the Y position to 0 and the toolhead move smoothly to the right, front of the build plate.
I then use the Toolhead window to set the X position 0 zero and the toolhead moves the the center of the build plate and rattles as it moves.
I've attached my printer.cfg file named as printer.txt
I send a G28 X Y command and the toolhead goes to the correct position, X 350 Y 350
I then use the Toolhead window to set the X position to 0 and the toolhead goes the the left, back of the print bed correctly.
I then use the Toolhead window to set the Y position to 0 and the toolhead moves to the middle of the board and rattles while moving.
I then send a G28 X Y command and the toolhead goes to the correct position at X 350 and Y 350.
I then use the Toolhead Window to set the Y position to 0 and the toolhead move smoothly to the right, front of the build plate.
I then use the Toolhead window to set the X position 0 zero and the toolhead moves the the center of the build plate and rattles as it moves.
I've attached my printer.cfg file named as printer.txt