What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Road to Voron

Hi all. New to the forum here.
I recently got a free 3d printer, or two, to be precise, from a friend, that I have been slowly modifying to hopefully get to the standard needed to print a 2.4 350x.

Current spec:
Monoprice Maker select V2.1 (Wanhoa I3 duplicator clone)
Usual Z brace mod, with custom rear brace.
Larger bearings on y carriage. 10 euro
Solid mounted stock y carriage.
Glass 'middle bed' - 20 euro
Steel/PEI magnetic build surface. 20 Euro
All metal Hotend. 35 euro
Extruder cold end fan shroud.
MOSFET swiched heater bed - 10 euro
Chopped down Repetier firmware "1.0" on the stock Melzi. (I had Klipper on it initially but it kept loosing connection.10 -15 different solutions didn't work. Marlin scrambled the LCD)
Have an SKR E3 mini coming next week. 35 euro

Hoping not to put any more money into it and save for the VORON from here...!!! :) 130 quid down as it is!
The printer came 2 very old rolls of PLA. They were enough to get the trouble shooting ball rolling.

Leveling the taco bed is the biggest issue with it. 6 hours over the last 2 days has it ok-ish.
 
Early days, complete with wrecked build surface and broken spool. One of the first prints was an extension for the spool holder to properly hold a 1kg roll.

IMG_20250419_153823.jpg



The printer as it sits now, moved to shed :)

IMG_20250519_195031.jpg


ABS printing some of the final upgrades. Will probably redo some of the PLA bits too. The secret to leveling it can be seen here. A bull clip at both high corners of the taco, to un-taco the hotplate.

IMG_20250517_153652.jpg
 
Last edited:
just fyi, pictures are not showing

Hi, thanks for confiming. I tried a few times to sort it but no joy. They show in the preview before posting.
Contacted a mod but heard nothing. Not sure if its a post count thing or if imgur is blaclisted, or what.

I started a log in discord instead. Not used it much before other than for voice chat and a small but of general chat. I guess this is one of the reasons why message boards are dying. Picture hosting/posting etc is far simpler on discord/social media platforms.

Link to the build log.
 
Printed a new cooler duct to fit a radial fan onto the cold end.

IMG_20250521_213304.jpg


Happy with where I've got to. Will finish of the final upgrades over the coming weeks and try some Voron parts after.
New E3 mini board has arrived and is mostly up and running with klipper.

It is almost plug and play. Just 2 connectors needed and 2 fan pins reversed.

IMG_20250523_230424.jpg


IMG_20250523_165422.jpg


IMG_20250523_230549.jpg
 
Top