Elijah
Member
- Printer Model
- VORON 2.4r2
- Extruder Type
- Clockwork 1
- Cooling Type
- Afterburner
voron 24r2 (by fysetc)+spider+2209+nema 17 hs29-2004s-c+rpi3b+
hi
hi. I'm new to 3D printing, I only had one already assembled.
I built VORON and there was a problem. when moving the print head, there is a crackling in the motors. at first, the problem was when moving the head with the arrows in fluidd along the Y axis, the head began to move diagonally and a crack appeared. then the crackling began to appear at different times when performing calibrations. but it happens that qrl and bed mesh calibrate are performed normally. and it is unclear whether these are problems in the settings or in the hardware. the answers I found on the Internet didn't help me... =(
the last time the crackling began to appear when parking the Y axis
hi
hi. I'm new to 3D printing, I only had one already assembled.
I built VORON and there was a problem. when moving the print head, there is a crackling in the motors. at first, the problem was when moving the head with the arrows in fluidd along the Y axis, the head began to move diagonally and a crack appeared. then the crackling began to appear at different times when performing calibrations. but it happens that qrl and bed mesh calibrate are performed normally. and it is unclear whether these are problems in the settings or in the hardware. the answers I found on the Internet didn't help me... =(
the last time the crackling began to appear when parking the Y axis
