What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Voron Tap issue - endstop always open

WestoftheWoods

New member
Hi all,

I have recently upgraded to boron tap and have encountered an issue, the endstop is always open, when I move the tool head up it's still open. I have tried to see what the issue is for myself but I can't really see anything that I have done wrong but I obviously have!

Could any one offer some advice? I have attached my printer.cfg and I will add that my inductive probe was working fine prior to this install.

Any help would be great :)
 

Attachments

  • printer.txt
    29.8 KB · Views: 14
I ran into that behavior with Tap and my Octopus. I tried putting the signal on the "proper" PB7 pin and that's what it did. I moved back to the STOP_7 PG15 pin where I had the inductive and later Klicky, and all was well again. This is with both a wired optical sensor and the V2.4.1 5-25V PCB (which is what I'm currently running).
 
We need some more information I guess. Where did you connect the sensor to the Mainboard, do you use a plain sensor or an Optotap version (if so, which one like "niemand" asked before).

What you can always check though is to take the sensor out and use a piece of paper to test if the state changes (use m119 command)
 
Top