Recent content by Driftrotor

What parts of the Display.cfg file did you change? Just been looking to see what you issue might be. Can you post up your Display and Printer .cfg please

Just make sure you select the correct ones you need from the list of options. 2 row 7 pins for the male connectiors I oredered 2 x 100 crimps because ya know... crimps

100PCS Micro-Fit 3.0 Connector crimps https://a.aliexpress.com/_EHeApbk

10PCS MX3.0 3.0mm Pitch Micro-Fit 3.0 2 row 7 pin Mini 5557 Male Shell 43025 https://a.aliexpress.com/_EwuHOnY

Sure can, are you on the discord server? Would make this a little quicker lol

Glad you got it sorted. In the end i got tired of this as i needed to do it every now and then. Further research found that the umbilicals are shorter than spec (probably down to cost saving) by about 10-20mm. I went full bore and got crimps and connectors and made up my own umbilical in the end...

Tulip Mod, need i say more... nudge wink

What do you consider high speed printing? 120 - 150mm/s is quite common with the V0 but you get good acceleration values (15-20k) and this is where the time saving really comes in. if you want to go faster you can but its not cheap as you will start to wander from the standard set up. but from...

Look no further, you can have a look here. (sorry couldn't upload them directly as they are too big apparently) https://www.dropbox.com/scl/fo/x7kkzi4wd0krp01dtnohk/h?rlkey=2u2tmtsy3y8skoea3v2pz2txy&dl=0 to give a brief idea of what i did... I wanted the side panels aswell as the front door to...

I have to say that the bed for me personally is spot on, only had to level it once as others have said and have had zero issues with it. So I'd be in the category of bed springs = yes, ABL probe = no. The top hat is much improved with the v0.2 variants but the cabling to the hotend still has...

I just posted a similar thred before seeing this. i too have this issue but mine i think stems from the connector crimps not making contact properly with the main pcb i might try something like a high flex 14 core cable to see if it improves the reliability currently I'm getting 100 hours or...

So I've been running my V0.2 for quite a while now (258 hours) and it runs like a champ, I even updated to the R1 version and is one of my go to printers. but i have been having issues with the umbilical on intervals... it seems to have issues with continuity on the plug and the main pcb (frame...

Unfortunately I don't seem to have a before picture of that area, but I have got a pic of what I did to mitigate what was happening on my machine. I have 1 layer between the motor blocks and the printed plate and 2 layers between the printed plate and the pcb of the umbilical. Before it...

after many hours pouring over the frame, gantry, rebuilding my tool head etc I can say I have tracked down the root cause of the strange resonances. here is a before and after shot of my adxl345 results. drum roll please.... it was the umbilical pcb and printed part fixed to the two motor...

thanx for your replay, i know this one might be tricky to improve on. i have tried mounting it on both the back of the strain relief and the tool head itself and both produced almost identical results. i used the same mount to do my dads v0.1 and he got some really nice results (18k for X and...