Recent content by Elijah

hi. could u to share ur printer.cfg on BTT 2240 and spider 3?

Hi to everyone. Say, please, where I can find pcb cap with holes for 5v fan for G2E? My CW cap with fan doesn't fit to Galileo 2...

Thank you, I did. but klipper now says that he is "dirty") is it possible to make this correction more "gracefully"?

my build VORON 2.4r2 (by Fysetc) based on Rpi 3B+ Spider 2.3 mellow UTOC mellow fly sb2040 voron tap(24v) by fysetc good afternoon, everyone. I get a constantly annoying error. in the process of executing homing or QGL, I get an error Communication timeout during homing probe. what could be...

seems easy enough, but apparently not enough. try re-racking gantry. Thx)

yes, flow calibration. I did the calibration of the grid, of course. these waves appear at any value of the flow on any models, on the covers and lower layers. I think it's all about the pinched X-axis. the Y-axis lines are wavy, and the X-axis lines are even.

VORON 24r2 от fysetc mcu spider 2.3 mellow fly can sb2040 mellow UTOC klipper 0.11.0-250 hello everyone. please tell, why there can be such strange lines?

thank you very much for your advice. I checked all the gearboxes, blew and cleaned each bearing, washers and replaced the washers with smoother ones. the clicks have stopped. Looks like some trash got in there.

I think it could be problems with belts, gear shafts or pulleys... no more ideas

it looks like the clicks are coming from the gearbox area. I checked with a stethoscope and it looks like it's him. the clicks are louder if the straps are tightened more. it all started with single clicks in the area of the left rear motor, a month later, when the belt is stretched above...

the assembly has been going on for more than six months. clicks appeared over time. and yesterday there were even more of them, from all sides. there is foam on the panels, yes

VORON 24r2 by fysetc mcu spider 2.3 can mellow fly sb2040 mellow UTOC klipper 0.11.0-250 Hallow, guys. tell, please, what kind of clicks can these be? the sound seems to come from somewhere in the field of 2 left motors...

big thanx! and special thanks for the configuration :)