Recent content by Gravel3170

Bonjour à tous. J'ai mis en oeuvre le G2E pour chacune de mes 2 V2.4 300 et j'ai pensé ajouter un retour sur mon expérience d'utilisateur: Pros: La mise en marche initiale s'est faite sans problème significatif ni ajustements compliqués. Les kits Triangle Lab étaient bien montés...

It's been a while since I first built my V1.1 ERCF. I'm not using it very often. I've seen all the changes made by the community in the background, and now I would like to get on with them. The question is: what changes should I adopt and where should I start? Will V2 bring together all the...

Waiting for the kit to be available again for a month..

180 for the Tap, 200 for the ERCF, 215 for the PLA... At the end your always waiting for that thing to get to some temperature. It becomes annoying.

Sure! https://www.facebook.com/groups/556127615824168/permalink/750018733101721/ https://github.com/moggieuk/ERCF-Software-V3 Found another repository but haven't tried yet: https://github.com/rourou/Voron_2.4/tree/main/ERCF

Found the answer on FB.

Hi! trying to do the klipper config of my newly built ERCF. First error messages tell me that many variables are not specified in the 'ercf' section of the "ercf_software.cfg" file like: "Option 'servo_down_angle' in section 'ercf' must be specified" Next message: "gcode command ERCF_UNLOCK...

Hi everybody! I'm in the process of building an ERCF. I'm wondering what solution of filament buffer you guys are using. There's many solutions out there: ERCP, Prusa's MMU2 buffer, Thingiverse...

My opinion is that you have a mechanical issue. Check the tightening of all your screws (magnets included). Are your belts well fastened enough?

I remembered the importance of doing the zero in z once the qgl is done. Hence the inconsistency of my first layer. Problem solved. Thank you all!

Yes I do. And I have to raise my Z offset by 0.15 to 0.20 every time.

Question here: Is it a must to have this 150 degc hotend temperature? When I print ABS every things expand while heating up and the zero setting is'nt good anymore. Then I have to play with fine settings until I get a good first layer. Annoying Thanks. Francis

Good idea for the Klippers team... :)

Is there a way to pause the print if the print head hits a part hard enough to trig the tap switch? Thanks.

This is a great add to the community. Thank you team!