Recent content by haydms

Ok for any newbie's like myself out there just building a Voron2 with Klipper (coming from the Duet world) Here was my answer after many searches' trials and tribulations. All the following was my fault however I could easily see it done by other builders. a) Reference X0 and Y0 have to be front...

ok scratch that after taking more stock of the situation. The calculations are ok, its my stepper movements (physical) that don't correspond to the calculations. i have Z0=stepper 3 Z1= stepper 4, Z1 = stepper 5 and Z3= stepper 7. I must admit I'm perplexed will try again tomorrow. Mark

Group, hopefully you can help me because I'm lost. The Z offsets sent to the motors are not correct (see below) when running a QGL. 9:08 PM Making the following Z adjustments: stepper_z = 6.572249 stepper_z1 = -5.637549 stepper_z2 = -6.653091 stepper_z3 = 5.718391 9:08 PM Average...

Rede, I have just done the same over Can bus so I'm going to try the following mod on the motor mount. I will let you know how it turns out. a_drive_frame_upper_with_jst_y_endstop_pinned below is the address of the mod...

Group, a quick question regarding QGL. I'm running a Voron2.4 with Tap and Can bus Manta MP8. Everything references fine until I initiate QGL (previously I had an issue with driver 6 going one way on Z it's a known problem on v1.1 boards, thanks to Shiftingtech for the answer and...

Shiftgtech, sorry its late, I'm old (so my wife says) and a horses a@@ at times, I was looking at version 1 last time I reprogrammed the *.cfg file not 1.1 signals, its working now and so is the CAN and Tap. Tomorow I will work on my other issues. thank you for all the help I...

Shiftingtech, your absolutely right it is in "Motor 6" and it is a MP8 V1.1 that's the issue. The problem now is for "Motor 7" the CS is PD12 that's also the can bus, so that's a no go unless i can change the can to another address (error: pin PD13 is reserved for CAN)...

Gents I need some advice on a Z axis home problem. Set up is BTT Manta MP8, Can Bus 2209 /2240 and tap. Sequence Home X Z goes up 10mm X goes to home through the Can Bus (no issues) Home Y Z goes up another 10mm Y goes to home (no issues) Home Z Z goes up another 10 mm X and Y go to...