Recent content by informel

put heater at let say 50 and touch it just to see if it's the sensor not reporting or the heater not heating. if it is not heating then you know it is the heater, it cousd be a broken wire/connection or the heater is not connected where is should be, did it ever work ? if it is heating then the...

The heat cannot change that fast, it is normally a bad connection on the heat sensor or broken wire on the sensor. The only other thing I can see is noise that the sensor is picking up

Yes clicky probe is slow but it is incredably precise for the Price

What I do not understand is that I don't recall installing that and normally you should have a line in printer.cfg that says include shell_command.cfg. but I have nothing in my printer.cfg that talk about shell

Thanks for the info, It's been a while that I did that and I was in Mexico for 3 months and don't remember a thing about that, but do remember using KIAUH, thanks

I was away for over 3 months and when I came back I update everything, now I have this error and I cannot find this section in any config, anyone has seen this

If it pass continuity all the way to the board, then it means that you are on the wrong connector

I found out that this is normal You are probably setup to do the resonance test and the PI as to be setup in a way to expose some GPIO pins and it shows as an additional MCU with limited capacity in order to keep the PI responsive

When I look inside Mainsail, I see this: mcu rpi(linux) Version: v0.11.0-279-g7bd32994 Load: 0.02, Awake: 0.00, Freq: 50 MHz, Is this normal ? Anything wrong with my PI ?