Recent content by JBryant

Do you have window access? I personally have my printers in a "grow tent" https://www.amazon.com/dp/B01DXYM98K?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1 with a vent fan https://www.amazon.com/dp/B0796NH8YB?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_4 exhausting out a nearby window. I...

I had the Prusa MK3S+ and MMU2 for several years and sold it after building my Voron with the intent to order the MK4S+ and MMU3. However Prusa's idea of "in stock" doesn't align with mine when it said shipping starts in 3 days turned into a 6 week lead time for my order. I cancelled it and...

Update, I was just running a 5 hour print and happened to be in the room when the neopixels turned off around 2 hours in. I issued the nozzle led off macro and the nozzle led on macro and they turned on for about 10 seconds and went black again. The chamber is at 56C. I wonder if these kit...

I'm torn between ordering the Prusa XL 5 tool head or building a Voron V2.4 based tool changer (likely stealth changer). I already have a functioning V2.4 Rev C LDO kit and would be adding another printer. For those that have done a tool changer, are there any parts that would not get used...

The logo led stayed red as commanded in my macros but the nozzle leds turned off. I looked in the console and there were no explicit calls to turn off the led but I didn't check any logs.

I'm running my first longer print on my newly assembled LDO V2.4 and until now the SB Leds were behaving as intended with colors changing based on STATUS lines in my Macros. Today, roughly 2 hours into a 4 hour print, the nozzle leds turned off, they should be white while printing. I was able...

59hz worked, I got a nice smooth heat trace up to 100C with no errors and minimal light flicker.

I just pulled the bottom cover off and my Omron SSR explicitly states 50/60hz so probably best to stay in that range. I did find an older post where someone used 59hz and it cured their flickering lights as well as the bed temperature drop off. I'll try that later and see how the temperature...

I recently finished my LDO V2.4 350mm build with the above mentioned LDO supplied bed and heater. I found that when heating the bed it would also make the led strip lights plugged in near the printer flicker. After much internet searching I found that the default PWM frequency for the Klipper...