Recent content by kholland15

Anyone experience a loud click or Pop on your Switchwire/Enderwire during certain printer movements? I know its not the extruder since I have heard it while the printer was homing. It seems to be more prevalent when the print head is 1" above the bed, but can happen when its higher or lower...

For the enclosure I used some parts from Fizzystech (https://github.com/fizzystech/ft_enderwire). Other brackets that were meant to put the VHB tape on both sides I drilled holes large enough to put M3 threaded inserts on at least one side. I then drilled holes in the panels to match where I...

I was seeing the same artifacts on my Mini Stealth Burner with CW2 until I switched to the Galileo 2 Extruder. The swirly ripples are caused by variances in the dual drive gears meshing. The issue is also exaggerated if you are closer to the max flow rate that your hotend can push. I have a...

Has anyone had success using the ERCF with PETG as the support interface layer for PLA prints, or vice versa? I have seen people claim they can do it with the Bambu AMS and get really good results with zero clearance supports.

I have no experience with this print, but it might help you cut a new pin straighter. https://www.printables.com/model/522529-dremel-cutoff-saw

Follow up to my previous post. I was having really bad layer shifting in the Y axis only when printing larger parts. Fixing it was a combination of belt tension and changing the stepper motor current in my printer.cfg. The kit calls for you to reuse the Y-axis motor from the Ender, but the...

My first printer was an Ender 3V2. I learned the ins and outs of 3D printing on it and I heavily modified it. Some of the main upgrades I did were CRTouch, PEI magnetic bed, BMG Extruder in Bowden configuration, Slice Engineering Bimetal Heatbreak with Copper Plated heat block, Gulf Robotics...

For me every time seems a little different. First time Klipper would report errors because the Hot end temperature spiked because the thermistor lost connection. The second time you could here the hot end fan stopping when the head was moving in different directions.

Anyone find a good solution to this? I had a couple cables fail and the intermittent connection also kills other components. I had to replace a heater with one cable and my latest cable failure killed the hot end fan too. I don't really want to switch to CAN if I can help it since I don't...

Hi All, I just finished building my Formbot V0.2 kit (still need to get Klipper running) but the kit came with a roll of 1x8mm single sided foam tape. I assume this is for putting between the panels and the frame to insulate better, but the manual did not mention this at all. Am I correct...