What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by KnotI

  1. KnotI

    Voron Pheonix progress?

    Sorry I thought I posted in general voron chat. Not sure how or if I can move this post. Thanks
  2. KnotI

    Voron Pheonix progress?

    Does anyone have any updates on the Voron Pheonix? Or know where to go to folow and/or be involved in the progress?
  3. KnotI

    Biqu BTT Knomi (and remix for nozzle camera)

    I really want to add a camera to my Trident. Which camera did you use? Where and how did you connect it to the board? I have the canbus board in my stealthburner but I dont think it will connect to it directly. Would love to know more about this and how it is working for you.
  4. KnotI

    SB2209 CAN V1.0(RP2040) wiring wont fit onder cover.

    I am have problems getting the SB2209 CAN V1.0(RP2040) wiring to fit onder the cover of the stealthburner. I did print the cover for the SB2209 but it is still pressing against wiring. Am I doing somenthing wrong? Is there yet another cover I can print or should I remove it altogether (would...
  5. KnotI

    Voron trident manta 8 wiring

    I am going through the manual for the wiring and I ran into this What is the reason to leave these disconnected. I am sure they will be connected at a later point, but was wondering what the hard learned lesson is.
  6. KnotI

    Sexbolt Neccessary with Euchlid probe.

    I was asking if I can use both I suppose? I wasn't entirely sure I could. What are the pros and cons to using both.
  7. KnotI

    Sexbolt Neccessary with Euchlid probe.

    Hello, new to voron but not 3D printing. The sexbolt Z endstop, Is it neccessary if I am using a euclid probe ?
See more
Top