Recent content by LightsOutLabs

Hi, So as 'm not getting much traction with selling this little fella, I've decided to persist. I was wondering, looking at the chamber temp when printing something in PLA, it was around 50, if it wouldn't be better to remove the side panels, the door and top hat for good, considering I only...

Hi, blind guy again. I'm getting dreadful prints, and noticed that the part cooling fans on either side of the head don't appear to be winding up. I've got a Revo hot end and the it's direct drive. I have a couple of questions: 1. Aside from using the k Klipper web interface to turn up the...

Okay, got it... The way the lever is seated was slightly far to the right meaning the latching aspect of it wasn't biting on the tool head. I loosened off the screw around which the hinge pivots and , holding it with pressure over to the left, tightened it. Now, it bites and clips down. This...

Thank you very much for your reply. So, do I simply screw the thumb screw in and then finness the latch and block to line up? I've tried this so many times. How far should the screw be in, it's got the spring so is very stiff. Is there something within the latch that should bite with the block...

Hi, Let me preface this by saying, I'm totally blind, so there may be some things I'm missing. A very kind chap built me a Voron V0.1 which I received yesterday. I think there was some damage during transport but I'll get that sorted. The A-Frame for the hot bed was canted down. I've just bent...

So, I'm just printing the parts for a Voron 0.1 and have come across two fSTL files which have confused me, one is HexNut_1515.stl and SquareNut_1515.stl. How many do I need of each of these? Also, I'm doing an LDO, or someone very kind is actually building it for me, how many of the...

Ah, this is exactly what I was looking for. There is a lot of very dry information to go through with rather mystical names. thanks for showing me where it is. Star. Thank you very much indeed.

Hi again, so, up and printing parts for my Voron 0.1. Went for galaxy black asa and Prusa orange asa too, if any are interested. Looking at the printed parts guide for the LDO rev E kit which I'm getting: https://docs.ldomotors.com/en/voron/voron01/printed_part_guide_rev_e It mentions this...

Ah, so it is making sure the minimum line width is 0.4 rather than the slicer skipping lines etc. I think I'm with you. In which case, I may have been changing the wrong settings. thanks

Hi, I'm attempting to print parts for a Voron 0.1 on my Bambu X1. I think I've added all the main aspects, 40 % infill, 0.2 layer height walls etc and (forced) 0.4 line thickness, though I'm slightly confused as to the last. I assumed that meant just put everything on 0.4 instead of 0.42 etc...

Thank you for the recommendation and clarifying ASA is workable. I've never printed ABS but have fed my Prusa and X1 a lot of ASA so at least I'm not messing about with a new material..

Hi everyone! Got some help over on reddit in the Voron sub and it was suggested I perhaps post here. So, I'm planning to get a LDO 0.1 kit and the supplier has very kindly indeed, said they'd build it for me, no charge! Love this community, it's amazing. I am blind, as I said in the title...