Recent content by llambion

I've read tons of post about canbus. Orange PI LTS custom preinstalled software don't have included necessary libs to work with canbus. I've swapped orange pi by a raspi 3B+ that i had in another project and now canbus works perfectly I was thinking about buy a orange pi 3B but I don't find any...

I bought a Voron 2.4R2 300mm Siboor kit in September. I've almost finished assembling it, I don't have much free time each week. I've added several mods such as hotkeys buttons on front skirt, chamber leds, pi camera, umbilical canbus, chaoctic lab tap and so on. Next week I believe that I will...

Hello everyone I have a raspberry pi 3B+ in my voron 2.4 and i want to replace it with a new SBC with 4gb and more power. I've seen a orange pi 3B and it seems a good sbc but i don't find any information about cameras. is orange compatible with ov5647 cameras? ara there any camera compatible...

have Anyone connected SFS 2.0 to a spider 2.3 mcu?

I have similar issue. I've installed ebb2209 + chaoticlab tap v2. I've wired tap to ebb2209 on x-endstop connector and always lights on blue. I've moved toolhead manually and it never changes color to red. I don't use Probe connector because it's died.

I have a siboor 2.4r2 kit. Mainboard is a spider 2.3 with a orange pi 3 lts. I've bought to add a canbus on my printer a EBB2209 toolhead module and U2C 2.1. First step that i did was uptade U2C firmware, i was ok after that i tried to make can0 port on orange pi3. I created can0 file in...

Yes, my kit arrived three weeks ago. At now, i'm ending to mount the voron. Last sunday, print my first cube test but it is necessary to adjust all printer parameters. I have a shift layer bugs, I need to improve the printer settings a lot I think that it is a good kit. It arrived so fast and...

Finally, I bought a Voron 2.4 R2 300mm on aliexpress thanks in a good offer with shipping from Europe for €725, this kit include necessary printed parts. Also, I bought a canbus parts and HDMI 5'' screen to mod my new voron. Thank you all for your advices. When the 3D printer arrives I will have...

I think I'm going to choose a Voron 2.4, I like more that the print surface is fixed on botton. Also, I have realized that where I am going to put the printer is a shelf cabinet with two more shelves where I have two paper printers and it goes on top of them. If I build a trident the base will...

I'm from Spain where import taxes for 'expensive' parcels are bit high. I'm searching a printer that print faster than ender3v2 with top notch quality, also i need enclousured printer that i want to print abs, asa and other technic materials. I know that you can personalize and create better...

Thank you for your anwser. It's clear to me from all answers that it's best to buy a kit rather than self-sourcing

Thank you for your advice!!

I am not considere 250 as a option. 300 should be my favorite option because I think 350 is too big and more expensive.

I have an ender 3 v2 printer for a couple of years and now I want to buy a better 3D printer. I want to print other materials like as ASA or ABS and i believe that i need a new 3D printer. I have read a lot about 3D printers models and I have decided that a voron will be a my new 3d printer but...