Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
I'm sure you already chose by now, but I have the Rapido HF on both of my Vorons and they are great hotends, no issues at all. They also come with 4mm and 6mm nozzles in the box. Just pay attention to sensor your version has as I recently had an "issue" with my Trident build. I didn't realize...
I had the toolhead PCB go out on my new 2.4 build a month ago. It would power up and print fine, then all of the sudden, the part cooling fan would turn on when and stay on constantly. I ended up taking it apart and noticed the wiring on the fan looked almost fried (prewired fan) and it must...
I buy my LDO kits from Fabreeko and they have the PIF parts as a purchase that you just add to the cart and they handle it. I just got a Trident kit from them a few weeks ago and did the PIF with the kit and I had the parts the next day. The printer was someone local, and his parts were about...
Yah, while I love TAP, it does seem to limit bed plate choices a bit :(
I have all HoneyBadger P-Series on my X1C carbons and love them (the dual sided w/ textured & smooth), they are fantastic. I wanted to get one for my 2.4 and came across the same info.
Not really sure what I want to do...
Thier performance is not what it used to be. I only buy top end micro sd cards and it just seems like there's a lot of micro stutters when doing things. The one hangs a lot but these old fellas have been used and abused a ton over the years, and up until building my Vorons, they were just...
Hello,
I just finished up my Trident and noticed my last two Rpi3's are starting to crap out on me. Luckily the one running the Trident mostly ok, but it does act up a little and I want to replace it with the BTT pi v1.2. I have installed and updated the BTT pi fully, so it's ready to go...
Yah, if you don't see any movement on it asap I'd cancel it. I buy my LDO kits from Fabreeko and they ship the same day, nothing in 2023 should take days / weeks when paying someone lol.
In Orca Slicer, make sure you go into the machine g-code settings tab and copy the print start string for the slicer. I noticed pretty much the same issue before I did that, it would heat to 150, probe, then shut down instead of heating up to print.
M104 S0 ; Stops OrcaSlicer from sending temp...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.