Recent content by thebigone2087

Hey all, I have a 350 DoomCube, so the high voltage components are on the bottom, and the controllers are on the top, running wires in the frame. I have my Rpi powered by a standard 5v means well supply with 24AWG wires but my Pi is constantly throttled showing under voltage warnings during...

Currently have a Switchwire with a BTT Mini e3 V3. I have had to wiring break a few times in the cable chain and would like to switch to CANBUS (I have run CANBUS on my old Trident and 2.4), but with the Mini e3 only having one mini-usb, I dont think that is possible? Curious if anyone here has...

Its less what they dont allow, and more what SS builds upon over PS. The SS github has all the additions over PS. SS is simply what I started with on my Voron over Cura, so its all I ever used.

Glad I am not the only one with SS support issues. I am going to try these PS Organic supports. moved my SS config over to PS (at least as much as they allow) so hopefully the quality isnt too much different.

So, as with most of you I am sure, I use and love SuperSlicer for my Vorons. I noticed there hasnt been a new release of SS since September. With PS adding the organix supports and seeing folks get really good results I was hoping to see that with SS. Is SS not being developed anymore or am I...

I need major help. I upgraded my Trident with CANBUS and a number of other things and ran pressure advance and input shaper (via SHAPER_CALIBRATE) and I have noticed some major ghosting on my prints. It was suggested I run the axis independently for input shaper then look at the graphs...

The 5648 is an autofocus model with fixed FOV.

I had an OV5648 on mine which worked perfectly, but its FOV was trash and I could only see a small part of the bed. Mind sharing where/how you have it mounted?

That’s exactly what is happening! Ugh… no real good camera solution for a trident. The C920 is too big and interferes with the SB during movements. Glad I’m not the only one though. Thank you!

I am having a genuine infuriating issue. I just added an OV5640 wide-angle camera to my Trident that I got from DFH. Got it mounted and I can finally see my whole bed, but it seems when the chamber temps start to rise the camera flickers to a point I cannot see anything. I’ve restarted the Pi as...

Totally possible. I am using the Fysetc double sided PEI sheet.

I was using a stealthburner set at 100%. I run my ABS between 40-60% with the same setup. The front doors are also open. Using some dish soap and warm water first, then IPA to clear off that. First layer speed was around 80mm/s. I did scuff the smooth PEI with 0000 Steel wool. I would get SOME...

Hahahah so true! I have all parts printed for a SW, just finished assembly of an ERCF, and am adding EBB36 CANBUS, steel backers, Nevermore, and a few odds and ends to the Trident. Just need the TAP files to release and I can get started.

Throwing some feelers out there to see if I am the only one having this issue. I CANNOT for the life of me get PLA to print reliably with my REVO. I can’t get it to stick to the bed, I can’t get a first layer down, I cannot get any type of calibration prints going with PLA, but I switch over to...

Haha I have a massive CANBUS upgrade to my Trident on pause because I want to do TAP at the same time