Question “Extruder” not hot enough error

[Tristan]

Printer Model

V2.4 r2

Extruder Type

Clockwork 2

Cooling Type

Stealthburner

When I try to start a print I get the error “Extruder” not hot enough. I have a Video and photos here of the problem and photos of the print start gcode also there

 

[5twenty]

Request sent....

But usually your start code in your slicer is sending the wait...unless you wrote that into your start macro?

And most will tell you how to remove the wait within the comments...usually something like:

M104 S190 ;set extruder temp to 190 C and don't wait
M140 S55 ;set bed temp to 55 C and don't wait

Or M190? I forget and I'm not in my dungeon on a computer with a slicer installed.