Hobbytastic
New member
I just got a Euclid probe to install onto my printer to replace the 3rd or 4th proximity switch that went bad on my board. Everything went smoothly until i printed the first print, put the machine back and repowered it. Since then the Probe stopped working. The indicator led lights up still when it picks up the probe. I switched the pin from EBBCan
B8,; where it was working on; to ^EBBCanB8 and finally to ^EBBCanB9 during trouble shooting. Checked all the connections from the board to the probe. I'm at a lost of what the issue could be. Its no longer reading that the probe is being picked up and im confused
B8,; where it was working on; to ^EBBCanB8 and finally to ^EBBCanB9 during trouble shooting. Checked all the connections from the board to the probe. I'm at a lost of what the issue could be. Its no longer reading that the probe is being picked up and im confused
