CFG files and order of operation

[roptics]

Can you provide a starting printer.cfg file that includes the needed information for the Nitehawk toolboard? The printer.cfg file that you list on github specifically lists configuration settings for the extruder, endstops, thermisters, etc. but if you use the Nitehawk toolboard all of that stuff needs to be reconfigured. Should I be adding the info from the Nitehawk-SB.cfg file into the appropriate [extruder] sections of the printer.cfg file OR should I be commenting it all out and then referencing a separate nitehawk-sb.cfg file at the end of the printer.cfg file? My full setup is as follows for when I DO get things working and then can maybe share a working configuration with others:

LDO Trident Rev. D
Nitehawk toolboard
Chaotic TAP CNC V2
Manta M8P V2 with CM4 eMMC
BTT HDMI7 screen

 

[5twenty]

Solved Thread 'Need some help with ldo sb nitehawk !!!'

Sep 5, 2024

Hello,
My printer was running fine up until a few days ago when I decided to update klipper. I’m not sure why things always have to go wrong after updating klipper but this time for some reason klipper screen stopped working turning my screen black. I tried a few things I found online but couldn’t fix it. So decided to just do a fresh install of klipper which has always fixed things for me in the past.
After I installed klipper my screen was fixed but now my printer is having connection issues.

Which I believe is being caused by nitehawk. I’ve been following the steps @ ldo but now things...

• Matt
• Replies: 4
• Forum: Electronics

 

[5twenty]

Should help get closer? If not...plenty of people here and disc to help more than I can...I've not gotten to my Trident yet.