D2HW switch standard deviation

[BrainErased]

so maybe i need some help
i'm getting standard deviation like 0.010426 which is not great not terrible right? or am i missing something?
i got similar results with klicky i got before upgrade to TAP with Omron D2HW switch

 

[NoGuru]

Is it causing an issue? It does seem a little out of spec. I would go through installing tap again and make sure its nice and tight and smooth.

 

[BrainErased]

Is it causing an issue? It does seem a little out of spec. I would go through installing tap again and make sure its nice and tight and smooth.

this week i disassembled and assembled almost whole 2.4 voron and yes lower Z joints and some screws in tap itself was loosend
now i geting standard deviation 0.001038

 

[NoGuru]

That's a good number.