Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
On my 2.4 the I am struggling to get the extruder to touch the xy limitswitch. It is running fine in the middel, but somehow it cannot get all the way back.
Can you post a photo of your gantry and your XY endstop? Where do you have it located? Do you use pod on the left XY joint with both switches, or on the A motor mount?
Did you de-rack the gantry?
Was a bit to fast to state solved. Now y is working, but x is grinding, and not moving. Have tried disconnect one motor at a time, and both seems to run correct.
Was a bit to fast to state solved. Now y is working, but x is grinding, and not moving. Have tried disconnect one motor at a time, and both seems to run correct.
Are you going through this guide? It's a really good document describing initial steps to get your printer going, including what to do in case movement goes different direction during homing.
Are you going through this guide? It's a really good document describing initial steps to get your printer going, including what to do in case movement goes different direction during homing.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.