- Printer Model
- 2.4 R2 350mm
- Extruder Type
- LGX
- Cooling Type
- Stealthburner
Hello everyone,
I have been working on my 2.4 350mm since last October and have had it at 99% for the past several months. The issue I have been struggling with is a highly variable nozzle offset. Some important info about my printer is its running a canbus, klicky probe, and sex bolt. I have checked to make sure the probe is tight, all belts are properly tensioned, and everything on the frame is square/secured. When I attempt to start the print, the nozzle will either be: a few millimeters too low and crash, a few too high, and sometimes (maybe 30% of the time) be very close to perfect. Since I feel I have tinkered with just about everything, I am thinking it has to do with the canbus somehow? Perhaps the polling rate is not sufficient and information is being dropped thus making the measurement unreliable but I am really unsure. I can attach any system files for my printer if that would be helpful, but I am unsure of how useful they would be since my problem is highly variable. I remember reading somewhere that the klicky probe should NOT be wired to the canbus endstop for some reason (which I did) but cannot seem to find this source again. Would be incredibly grateful for any advice. Thank you!
I have been working on my 2.4 350mm since last October and have had it at 99% for the past several months. The issue I have been struggling with is a highly variable nozzle offset. Some important info about my printer is its running a canbus, klicky probe, and sex bolt. I have checked to make sure the probe is tight, all belts are properly tensioned, and everything on the frame is square/secured. When I attempt to start the print, the nozzle will either be: a few millimeters too low and crash, a few too high, and sometimes (maybe 30% of the time) be very close to perfect. Since I feel I have tinkered with just about everything, I am thinking it has to do with the canbus somehow? Perhaps the polling rate is not sufficient and information is being dropped thus making the measurement unreliable but I am really unsure. I can attach any system files for my printer if that would be helpful, but I am unsure of how useful they would be since my problem is highly variable. I remember reading somewhere that the klicky probe should NOT be wired to the canbus endstop for some reason (which I did) but cannot seem to find this source again. Would be incredibly grateful for any advice. Thank you!
